Search results

  1. Cougar_Marauder

    Metco Driveshaft Loop with Stainless Works exhaust?

    I have this setup... mostly. I had my X-pipe switched out for an H-pipe. I did have to drop it down to get the loop up there. It wasn't too bad of a job for me.
  2. Cougar_Marauder

    Widened front rims

    It's been a while. I did more research and ran my own calculations and came up with very different numbers than I found on here previously. An OEM Marauder rim has an offset of +50.8mm(2") on 8" ID; making it a pretty damn high offset. Increasing the rim width toward the shock increases the...
  3. Cougar_Marauder

    Widened front rims

    From what I gather, the spacers are only needed for the stock rims or stock offset of +50 on 8" wide wheels. No spacers needed with 10-11" rim at +40. The biggest problem now is finding a set that wont break the bank. Ideally I want 20x10 +35-40 in front and 20x11-11.5 +40 in the rear.
  4. Cougar_Marauder

    Widened front rims

    Upon further research I have decided to go with a 20" rim setup instead of widening the stockers (even though I love the stock look). From what I can find for the rear 20x10 +40mm offset with 305/35-20 should work (or 20x11 but that is hard to find a match with a skinnier front). For the front...
  5. Cougar_Marauder

    Widened front rims

    Hi all, I plan on having my rims widened soon but there is not much info on the front rims. I plan to have the rear rims widened to 9.5-10" with 295/45 18 and the fronts to 9.0-9.5" with 275/40 18. The rears are well documented but the only real info on the fronts I could find was Motown...
  6. Cougar_Marauder

    Wanted To Buy Wanted: Colex polished fluid caps

    I have an oil one. Could use a nice polish but in great shape.
  7. Cougar_Marauder

    Eibach Front Lowering Springs GROUP BUY

    I would be in for one set.
  8. Cougar_Marauder

    Trying to start rebuilt engine. Gassing plugs

    My FRPS recently went out on me and after it flooded the first time nothing I did worked until I put all new plugs in. It's worth a shot at least. https://www.mercurymarauder.net/forums/showthread.php?107676-Will-not-start
  9. Cougar_Marauder

    Will not start

    Thanks decipha, I did pretty much as you said and also installed my stock FPDM and it fired up. I guess I never experienced a vehicle that will flood so badly! :burnout:
  10. Cougar_Marauder

    three gauge center console pod

    I went with 2 gauges from Aeroforce, one plugs into the OBD and the other accepts whatever analog input you run to it and you can display 2 things at once. I have vacuum/boost and AFR on the analog. Kinda pricey but retains the stock look.
  11. Cougar_Marauder

    Will not start

    I found the FRPS to be bad initially but I replaced it. Today I cleared out any gas that may have been sitting on the cylinders and now it kind of stumbles but wont start, it wont even stumble unless I hold the pedal down to the floor. I checked for engine codes and have a P0190 and P1233. I...
  12. Cougar_Marauder

    Will not start

    I put a modified FPDM from RacerX back in 2014. I can see if I can find the old one just to be sure...
  13. Cougar_Marauder

    Will not start

    Fuse on Boost-a-pump looks OK. Yes I can hear the pump hum when turning the key on.
  14. Cougar_Marauder

    Will not start

    03 Trilogy tuned at Lidio. Aeromotive Stealth fuel pump. Boost-a-pump (dialed down low), relatively new spark plugs, JLT CAI A few days ago I put the battery back in the car and it fired right up. I made a few short stops and it fired up fine each time...until it didn't. After about a 20min...
  15. Cougar_Marauder

    TCI 3 quarts trans pan

    I believe BMWs (or at least mine) uses this type of plug as OEM equipment....but that's apples to oranges.
  16. Cougar_Marauder

    For Sale engine compartment a/c decal

    Is there any way to get a custom one? As in showing the belt configuration with a Trilogy?
  17. Cougar_Marauder

    Leaky injector

    So I'm back to square one on this. I did the sound check on all my injectors and they sound good. I put a fuel pressure gauge on the rail where the Schrader valve was and it is only reads 30psi but data logging shows me at 40psi, so I bought a new FRPS. No change with the new sensor. So did I...
  18. Cougar_Marauder

    Leaky injector

    I only smelled gas while waiting at the stop light just before the first time it stalled. I checked for any fuel smell in the vacuum hose attached to the FRPS and there was none. I also took the FRPS off to try and blow through it and I couldn't. There didn't appear to be any pressure in the...
  19. Cougar_Marauder

    Leaky injector

    I believe I have a leaky injector. My car stalled on me 2 times now, both times I was sitting at a stop light and after a slight acceleration and letting off the throttle it stalled. The first time it happened I could smell gasoline (the tank was also nearly empty). I did some data recording...
  20. Cougar_Marauder

    Anyone near Cadott, WI?

    I'm not sure how late you play; if this would be feasible, I live in Neenah, 2.5 hours away. I have a spot in my basement you can sleep in. The next day I'm throwing a party and you can stay for that too! It's far away but I'll toss it out there.
Back
Top