FPDM what's needed to Upgrade

BeeDamn

BeeDamn

Maraudest
Hi everyone it's been a while since I post here and I'm in the final process of installing eaton swap.

Actually I finished everything (hopfully) and the tunner (marty) said my FPDC % is high and need a dual or bigger one, So I bought another AEM and modified the hat a little bit. But I don't know if the wires need upgrading or not ?

And most importantly the FPDM upgrade what's need to be changed, Is it the transistor? The Capacitor? The Inductor? Or the Diod? And which spec do I need?

Please I need your help guys and I already asked Racerx but he's been awhile since his last time available.

Thanks
 
I'm in the same boat...I wanted one but Noone seems to be modifying them anymore. I can do board solder work so if someone has the spec on what exactly was changed and the parts it'd be simple to modify my own.
 
robertmee said:
I'm in the same boat...I wanted one but Noone seems to be modifying them anymore. I can do board solder work so if someone has the spec on what exactly was changed and the parts it'd be simple to modify my own.
Click to expand...

I have a RacerX modded one you can try.
 
robertmee said:
I'm in the same boat...I wanted one but Noone seems to be modifying them anymore. I can do board solder work so if someone has the spec on what exactly was changed and the parts it'd be simple to modify my own.
Click to expand...

http://www.black306.com/?page_id=13

Upgrade the relay to a 30 amp as well. Keep the 20 amp fuse unless you upgrade the wiring. I didn't and have no issues except for the standard 20 amp relay.
 
Last edited:
Looking for the part numbers for the components used in the modification so I can make some of these. Repeated PM's to RacerX have not resulted in any replies.
 
fastblackmerc said:
Looking for the part numbers for the components used in the modification so I can make some of these. Repeated PM's to RacerX have not resulted in any replies.
Click to expand...

He posted on the other site a couple times recently. I wrote him there because he owes me a new unit under warranty for well over a year now which he agreed to and he won't respond anymore. I wouldn't say anything but it's been a very long time and I believe he has had time to regroup or whatever he is up to.....
 
tbone said:
He posted on the other site a couple times recently. I wrote him there because he owes me a new unit under warranty for well over a year now which he agreed to and he won't respond anymore. I wouldn't say anything but it's been a very long time and I believe he has had time to regroup or whatever he is up to.....
Click to expand...

PM'd him from the other site.
 
Anybody remember the guy's name who originally did the mod and sold them on ModularFords forums?
 
Been out of the loop for awhile, go this from ModularFords:

After MJChip (Zone5) closed shop there was someone on Corral that was making the hopped up FPDMs for a while (perhaps still is) although I don't recall who. You might want to just use two FPDMs, one for each pump. That way if one failed you could easily replace it with a stock unit from a local parts store.

I sure hope mine dosen't fail since it seems nobody makes them anymore.
 
I'm collecting parts and will likely start modifying them in 2 or 3 weeks. I expect the cost will be close to the same.
 
f926aa83d5659cfaee2f25d642ba2f39.jpg
Modified FPDM. upgrade the wires when using the modified units. The stock unit is good enough with upgraded wires. I removed the modified unit and replaced with two stock units when I went with dual pumps.
 
You must log in or register to reply here.
Back
Top