Metco Driveshaft Loop with Stainless Works exhaust?

X

xxfonziexx

New member
Does anyone have the Metco driveshaft loop installed with Stainless Works exhaust and headers?

I want to install one, especially as I'm planning a gear swap to 4:10s soon.

If you do have that combination, how was the installation? I was thinking of dropping the exhaust to get it installed, but the whole thing is welded.
 
I have this setup... mostly. I had my X-pipe switched out for an H-pipe. I did have to drop it down to get the loop up there. It wasn't too bad of a job for me.
 
Thank you!!!

Also, damn it. I think that's project that's going to get put on hold until I have a really good reason to take that exhaust apart.
 
You must log in or register to reply here.
Back
Top