overdrive flashing

Y

yryr999

New member
Hello
today when I'm coming from work .. the overdrive light flashing for around two minute I feel the trans shifting going strong and the rpm up around 1200 when i shift to natural the rpm goes down .. after that the overdrive stopped flash ...
I changed the fluid last month with the filter .. ?? what will be the problem ...?
 
Happened to mine, ended up being overhauled by dealer. Warranty covered it so I walked happy.
 
Overdrive light was flashing on me once a few years ago after an epic first gear burnout, but never happened again, needless to say though, that was my last epic first gear burnout!
 
9/8/09 @ 58691 miles Overhauled transmission with converter and valve body wiring replacement (o/d light flashes with delayedshift)
10/19/09 @ 60092 miles replaced transmission bulkhead wiringand connectors (o/d light flashes with no shift in o/d)
 
Could be anything. The light is flashing because a code is present. Take it to a reputable transmission shop to have it diagnosed.
 
There was a problem in the past where the direct clutch snap ring would pop off and then no drive after an upshift to 3rd. It supposedely happened after a hard forced downshift from overdrive to second gear (like when cruising along with almost no throttle and them mashing to to pass someone).

Either way, I am afraid it's going to be toast.
 
Today the check engine came on and it give this codes p1702 & p0705
What that's mean I didnt understand it ..
 
fastblackmerc said:
There is this thing called the internet.....

On this internet thing is something called google
........

It works like this, go to the internet, go to google, ask google to look for anything you want.

Found this in 10 seconds.....

http://www.obd-codes.com/trouble_codes/ford/
Click to expand...

I did look at this website but I didint find a causes .. I just find a code ..
For that I wrote the code here .. Maybe someone had this issue before

But thanks any way for your help
 
P0705 Transmission Range Sensor Circuit malfunction (PRNDL Input)

Possibly a bad/misadjusted DTR (Digital Transmission Range) sensor...that's fairly common.

Also check the connector...hit it with some WD40 or CRC and make sure it's seated properly.
 
Mine did this two times or so... while i was driving so i stopped turned the car off both times and turned it back on... hasnt done it ever since i have no idea what this was...
 
You must log in or register to reply here.
Back
Top