You can use fishing line also and yes you will have 2 holes left under badge that the factory uses to align the emblem during installation so use the line floss and move from top down to center and then from the bottom up to the center.
It's all in the heat gun and how much you apply. Apply too much and you ruin the paint. Apply heat and then slip a piece of thin cardboard under the top of the emblem. Use a broad tip screwdriver between the cardboard and emblem and gently pry the emblem off as you apply more heat. Just be careful not to apply too much heat and do not use too much pressure on the screwdriver. The emblem will start to give as you wave more heat on to it.
I know this is an old thread, but I'm hoping will reply...
I am planning on removing my trunk emblem and have plenty of fishing line but no heat gun. I have a hair dryer somewhere and an extension cord, but is the heat truly needed?
Almost forgot I posted this. Thanks for the replies! I plan on removing the rear badge in order to put something else in it's place. I do like the shaved look on cars but I have other plans. I will post pics when done. Here's a hint, the car will be renamed Marauder Prime. Thanks again!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.