Turn Signal heated Mirrors

I am now a dealer for these. I like these a lot some of you may not, I wanted Blue but they only come in Red they work with your flasher or brake lights and turn signals there easy to install and they are heated. I may try and make them wig wag or sequential now that would really be neat.

00-00-1275237368-DRBRAKELIGHTWITHMIRROR.JPG.jpg



00-00-1275237393-DRLEFTSIGNAL.JPG.jpg



00-00-1275237437-DRMIRRORSIGNAL.JPG.jpg
 
I like the idea but most of them a stick-ons which I won't use and the Muth's are too expensive at $269.00 for me.
 
where can i find these mirrors i looked on reinhart website can sum one steer me in the right direction
 
The company sent me a set for free, they install is pretty easy if we do a group buy, I am sure I can offer a good price. I will let every one know Tuesday. This is a quality product the OEM Heated mirror snaps off, you then take off door panels and remove the three 10 MM nuts holding the assembly on the door, you thread the signal wires through the harness re'install the mirror it pops on and locks in place, the passenger side wires run over to the drivers side kick panel and you scotch lock, the passenger side to the Orange with blue stripe and drivers side goes green with orange stipe these go to the wires running to the tail lights, so the mirror lights work with the turn signals as well as the brakes and the 4 way flasher. They come with all the hardware and instructions.
 
Last edited:
I've seen the factory installed mirror turn signals where the LED's are recessed into the mirror assembly or the mirrors are ported with the LED's. This way the driver does not see the LED's in the mirrors when activated, which would be blinding at night otherwise.
Question: Are these "snap-on" mirror turn signal indicators surface mounted ? What is the glare factor to the driver at night ?
 
This way the driver does not see the LED's in the mirrors when activated, which would be blinding at night otherwise.

What is the glare factor to the driver at night ?

Hi Vtwoodsman

All the mirrors that I have seen with built in turn signal LEDs you cannot see them from the drivers seat.

Regards

Dereck
 
Dennis, is it possible to wire these so they DON"T work with the brake?

Thanks,
DUMBO
 
Last edited:
Back
Top