What did you do to your car today?

Comin' in Hot said:
The master switch could cause the other switches not to work, my advice would be to swap it out for a master switch from one of your other marauders and see what happens.
Click to expand...


I agree. Once verified bad, just take it apart and clean the contacts every two years or so. Takes five minutes with a Dremel and a brass wire brush bit. Or buy another one that will do the same over time.


Builder Of Badassery
 
Well I got it put back together using wires run from the battery back to the door. After it was all back together when I went to pull it out of the garage I tried to roll the window down with the master switch and danged if it was now working. I am at a loss as to why.
 
d60e59676cc034422936c358672f0ec3.jpg

Washed the body

bdddbc9da94046e97c5343da8b7107aa.jpg

Cleaned engine bay
 
Currently marauderless, well drivable marauders anyway. My DBP is in my garage waiting for parts and my black is in the driveway with the front suspension ripped off. I decided it was time to install my Eibachs, KYBs, SPC camber bolts, and 14" brake upgrade. I noticed I had a torn upper ball joint boot and all the bushings looked horrible. I ordered new control arms, swaybar end links and bushings. I spent far too long notching the cross member for the camber bolts today. Hopefully I 'll have it back together in a couple days.

 
4.10

Just got a new set of 4.10 off e-bay for a dam good price. I washed the car and will not drive it much do to the weather at time's. Plus going to start polishing it.
 
Last edited:
Filled her with gas, added Star Tron to the fuel, drove her home, backed into the garage... tonight I am going to change out the headlight controller, and pull the battery...night night...
 
I got her all new OEM headlights, side markers and fog lights... Sounds like it's about time to install that mesh grille and finish the mod on the new OEM bumper I've had laying around... [emoji16]
 
Invader said:
I got her all new OEM headlights, side markers and fog lights... Sounds like it's about time to install that mesh grille and finish the mod on the new OEM bumper I've had laying around... [emoji16]
Click to expand...

Did you get the oem right side new? Ive been looking everywhere.
 
Nitrous

Got my nitrous system working again. Got a hand held "activate" switch from
Summit Auto.

The old unreliable purple box is just a shell housing the two solenoids, now activated by my hand grip switch. The power switch is still in the door.
 

Attachments

  • DSC05869.jpg
    DSC05869.jpg
    29.8 KB · Views: 46
  • DSC05870.jpg
    DSC05870.jpg
    22.4 KB · Views: 43
You must log in or register to reply here.
Back
Top