redmercy04
New member
Really pic please.Just put the Husky weather mats in to catch the sand in my yard and to protect the original floor mats. They fit perfectly.
http://www.amazon.com/Husky-Liners-...&redirect=true&ref_=oh_aui_detailpage_o07_s00
Really pic please.Just put the Husky weather mats in to catch the sand in my yard and to protect the original floor mats. They fit perfectly.
http://www.amazon.com/Husky-Liners-...&redirect=true&ref_=oh_aui_detailpage_o07_s00
Dusted off the hood this evening. Does that count?
Hey I have owned an mm03 for 9 months I've only driven it 2000 miles. I have a misfire on #8 no code, not over heating, not the spark plug, it's not the coil, it's not the injector, it's not the valve seat coming lose, did I mention no code, what is it? Please help. I want to drive it. I really do. Thanks.
Marauder 03
The blend door motor took a dump on Saturday ....since the weather is crappy here I did it this morning at the shop I work at. Wasn't too bad it took me two hours. The new motor from Ford cost me $62 wholesale. I followed the sticky and it was pretty much right on, but would would add a couple steps...
1...I removed the steering column trim cover and metal knee bolster, and loosened the two column nuts and removed the dashboard mounting bolt on the drivers side. This lets you pull the dash that little bit extra for us guys that don't have small hands or skinny arms.
2...Using a 1/4" air ratchet will make life much easier in getting out the two front screws....I snapped the rear tab off and only mounted it with the front two screws. In my 15 years at Lincoln and Ford I don't think any of those rear tabs got used...never an issue.
3... On the right side vent tubing cut a slot in the top mounting hole so that you can start the screw before putting in the tube again. That makes it much easier than trying to start a screw in a blind hole.
Yes I cleaned out the tube, it was nasty inside.
![]()
This is what I think of the blend door motor.![]()
![]()
Good for the tailpipes as well. Then applied a wax. Helps to keep the brake dust off and road grime. Mine were pretty good to start with.I am sure it will very depending on the condition of wheels.
Sent from my XT1585 using Tapatalk
I got almost 130K, after sitting over four years!Turned 26K this afternoon
And I'm crying over mines sitting over 3 months. I need to be more humble. [emoji21]I got almost 130K, after sitting over four years!
Sent from my XT1096 using Tapatalk
I went to the local track today & the best time out of 7 runs was
13.61 @ 101.76 mph with ZEX NOS 75 shots
Car # 300
I have to practice more on launching. :burnout:![]()
Good job Gordon!
Read up on flashing the converter. My first time out Zack told me but I didn't really understand. I can't wait to get to the track again, stupid responsibilities!!!
How much rwhp and boost? Good jobI raced a 2013 srt8 challenger and beat him 3 times and man was it fun. they just got the car today too. lol all I have is a stock eaton on 10lb boost and stock 3.55 gears. all tuned by marty'o mo's speed shop.